The RTT overflow callback is not available on all RTT implementations.
This means it is either a no-op or `rtt_set_overflow_cb()` is a no-op
or it will overwrite the alarm set with `rtt_set_alarm()`.
This adds a feature to indicate that proper overflow reporting is available.
Some periph_rtt implementations do not provide `rtt_set_counter()`. This
adds `periph_rtt_set_counter` as feature to allow testing for its
availability. The feature is provided at CPU level if periph_rtt is
provided by the board for all CPUs implementing `rtt_set_counter()`.
Some periph_rtt implementations do not provide `rtt_set_counter()`. This
adds `periph_rtt_set_counter` as feature to allow testing for its
availability. The feature is provided at CPU level if periph_rtt is
provided by the board for all CPUs implementing `rtt_set_counter()`.
- Adds capabilities for each PHY mode. Converts the uint16_t caps field to an
uint32_t in order to hold all capability bits, size of the structure remains
unchanged due to alignment.
- Modifies the test application to configure the PHY mode using the shell
command. Also adds the PHY modes to the capabilities shell command.
- Updates the nrf802154 and cc2538 radio drivers to specify the PHY mode
supported.
Signed-off-by: Jean Pierre Dudey <me@jeandudey.tech>
This commit sets the correct value to the MCU_CTRL bit for the
cc2538_rf. This variable is used to detect when the radio is doing
transmission with CCA. Since this was not set to 1 when sending without
CCA, the `confirm_transmit` function returned -EAGAIN after the TX_DONE
event (which violates the HAL API).
This error was discovered using some Radio HAL riotctrl scripts by @LarsKowoll.
If the same callback function is used for multiple interfaces
(`NETDEV_INDEX_ANY`), it is necessary to also provide the index of
the interface to hand out and address.
Add periph_uart_nonblocking. Since cc2538 has a transmit FIFO write
to the FIFO first and to a tsrb buffer only when the transmit FIFO
is full.
Rely on the FIFO TXIFLSEL condition to fill up FIFO as space becomes
available.
Flash Customer Configuration Area (CCA) is never written when the
riotboot module is used. This required a riot application to have
been previously flashed. riotboot will completely ignore this
section, neither writing or erasing it.
Slot flashing is currenly only supported with Jlink.
Co-authored-by: Brenton Chetty <brent7984@gmail.com>
