For a number of STM32 MCUs with the USB-FS device interface the signals USB_DP and USB_DM are not defined as GPIO alternative function but as additional function. Additional functions are directly selected/enabled through peripheral registers hand have not to be configured. In this case, the configuration defines GIO_AF_UNDEF as alternative function.
Makefiles don't do comments, so these were forwarded into the variable.
*Most* users would expand the arguments to a shell where it'd be
ignored, but not all of them.
Contributes-To: https://github.com/RIOT-OS/RIOT/pull/18489
(This is also where the one version that is added here was removed).
Add tracing support via GPIOs to trace the basic state of the Ethernet
peripheral. The following signals are provided:
- One GPIO pin is toggled on entry of the Ethernet ISR
- On TX start an GPIO is set, on TX completion it is cleared
- On RX complete an GPIO is set, once this is passed to the upper layer
the GPIO is cleared again
In order to reduce the overhead, GPIO LL is used. By default the
on-board LEDs are used as tracing GPIOs. This makes it easy to debug
when the state machine gets stuck without the need to attach a scope or
logic analyzer.
A if `netdev_driver_t::confirm_send()` is provided, it provides the
new netdev API. However, detecting the API at runtime and handling
both API styles comes at a cost. This can be optimized in case only
new or only old style netdevs are in use.
To do so, this adds the pseudo modules `netdev_legacy_api` and
`netdev_new_api`. As right now no netdev actually implements the new
API, all netdevs pull in `netdev_legacy_api`. If `netdev_legacy_api` is
in used but `netdev_new_api` is not, we can safely assume at compile
time that only legacy netdevs are in use. Similar, if only
`netdev_new_api` is used, only support for the new API is needed. Only
when both are in use, run time checks are needed.
This provides two helper function to check for a netif if the
corresponding netdev implements the old or the new API. (With one
being the inverse of the other.) They are suitable for constant folding
when only new or only legacy devices are in use. Consequently, dead
branches should be eliminated by the optimizer.
A single character type resulted in way fewer TX descriptors being
available than allocated. Not only resulted this in wasting memory,
but also when more iolist chunks than descriptors are send, the
```C
assert(iolist_count(iolist) <= ETH_TX_DESCRIPTOR_COUNT);
```
does not trigger. As a result, old TX descriptors are being overwritten
in this case.
An network devices that supports netdev_driver_t::get(NETOPT_LINK, ...)
also has to emit NETDEV_EVENT_LINK_UP and NETDEV_EVENT_LINK_DOWN with
lwip for IPv6 duplicate address detection to work. The background is
that the STM32 Ethernet MAC requires a periodic timer to poll for the
state to emit these events. For this reason, `stm32_eth_link_up` was
introduced to allow applications to select if they need these events.
With this dependency in place, IPv6 addresses won't get stuck in a
tentative state any more.
