If a write to a full tsrb is attempted with disabled interrupts
or in a interrupt then a deadlock will occure. To avoid this make
space in the ringbuffer by synchronously writing to uart.
The UART TX and TX lines on SAMD5x and SAML1x can be inverted.
However, the flags don't do exactly what one would expect.
See errata 2.18.5: SERCOM-UART: TXINV and RXINV Bits Reference:
> The TXINV and RXINV bits in the CTRLA register have inverted functionality.
>
> Workaround:
> In software interpret the TXINV bit as a functionality of RXINV, and conversely,
> interpret the RXINV bit as a functionality of TXINV.
When the SPI peripheral is disabled, the output lines will become HIGH-Z.
If the clk pin is not pulled HIGH or LOW, connected SPI slaves will start drawing current expectedly.
Writing a 1 bit clears the interrupt flag, writing with |= is thus
uneccecary (and actually an error as this would clear *all* flags).
This cleanup was already done for rtt.c, but rtc.c missed out.
The sam0 MCUs all have a DAC peripheral.
The DAC has a resulution of 10 or 12 bits and can have one or two
output channels.
The output pins are always hard-wired to PA2 for DAC0 and PA5 for DAC1
if it exists.
On the same54-xpro I would only get a max value of ~1V when using the
internal reference, so I configured it to use an external voltage reference.
The external reference pin is hard-wired to PA3, so you'll have to connect
that to 3.3V to get results.
For consistency, use named GCLKs.
- `SAM0_GCLK_32KHZ` will always be 2 for samd21
- `SAM0_GCLK_MAIN` will always be 0
So no change in functionality, just makes the code easier to understand.
bitarithm.h is not needed for the interface of shed but may cause conflicts
due to different definitions of SETBIT and CLRBIT
common implementations are: (value, offset) xor (value, mask) bitarithm
implements the later
frac.c and nrf52/usbdev.c use bitarithm.h but where missing the include
sam0/rtt.c defined a bit using mask from bitarithm,
changed that to the soulution used in sam0/rtc.c
Instead of hard-coding the peripheral clocks to CLOCK_CORECLOCK
introduce helper functions to return the frequency of the individual
GCLKs and use those for baud-rate calculations.
This requires the GCLK to be part of the peripheral's config struct.
While this is already the case for most peripherals, this also adds
it for those where it wasn't used before.
As it defaults to 0 (CLOCK_CORECLOCK) no change is to be expected.
To simplify board definitions and for unification between samd2x and
newer models, don't use the GCLK bitmask in board definitions.
Instead use the GCLK index and generate the bitmask when needed.
The common ADC API dictates that a sample call must return -1 on an
incorrect resolution. The sam0 ADC implementation instead threw an
assertion failure.
Currently, spi_acquire() will always re-configure the SPI bus.
If the configuration did not change, this is entirely uneccecary
and makes SPI operations take longer than needed.
Instead, compare the current configuration with the new configuration
and skip the initialisation if it didn't change since the last call.
