19593: boards/msb-430: add documentation r=maribu a=maribu
### Contribution description
This adds basic documentation, schematics, pinouts, and info how to get started with the `msb-430` board.
19597: sys/shell: Add coreclk command to shell_cmd_sys r=maribu a=maribu
### Contribution description
The coreclk shell command now prints the CPU frequency in Hz, which can be useful for boards with RC generated CPU frequency (e.g. RP2040, FE310, or MPS430Fx1xx MCUs allow this) which may quite a bit off the target frequency.
Co-authored-by: Marian Buschsieweke <marian.buschsieweke@ovgu.de>
Provide a common clock initialization driver rather than leaving
clock initialization to the boards code. A declarative description of
the board's clock configuration using a struct does still allow to
fine-tune settings. In addition, a board is still allowed to just
provide a custom `void clock_init(void)` if there really is the need
to do crazy things.
- most were trivial
- missing group close or open
- extra space
- no doxygen comment
- name commad might open an implicit group
this hould also be implicit cosed but does not happen somtimes
- crazy: internal declared groups have to be closed internal
The file always exist so no need to do '-include'.
Replaced using:
sed -i 's|-\(include $(RIOTCPU)/.*/Makefile.features\)|\1|' \
$(git grep -l '$(RIOTCPU)/.*/Makefile.features' boards)
- Use RIOT's GPIO interface to access the sensor to increase portability
- Changed API to allow more than one sensor per board
- Added `sht1x_params.h` that specifies how the sensors is connected - each
board can overwrite default settings by #defining SHT1X_PARAM_CLK and
SHT1X_PARAM_DATA
- Changed arithmetic to use integer calculations only instead of floating point
arithmetic
- Added support for checking the CRC sum
- Allow optional skipping of the CRC check to speed up measuring
- Added support for advanced features like reducing the resolution and skipping
calibration to speed up measuring
- Allow specifying the supply voltage of sensor which heavily influences the
temperature result (and use that information to calculate the correct
temperature)
- Reset sensor on initialization to bring it in a well known state
- Support for the obscure heater feature. (Can be useful to check the
temperature sensor?)
- Updated old SHT11 shell commands to the new driver interface, thus allowing
more than one SHT10/11/15 sensor to be used
- Added new shell command to allow full configuration of all attached SHT1x
sensors
- Removed old command for setting the SHT11 temperature offset, as this feature
is implemented in the new configuration command
