In the feather-m0 board the sx127x pin parameters are hardcoded for the
feather-m0-lora variant, but this is not compatible with other
configurations.
For example in the feather-m0 adalogger PA06 and PA08 are used for the
SD card. When combined with the RFM95W FeatherWing the IRQ/CS/RST pins
must be wired, and then the sx127x pins must be configured to match the
wiring (which will be necessarily different from the lora variant
configuration).
Instead of hard-coding the peripheral clocks to CLOCK_CORECLOCK
introduce helper functions to return the frequency of the individual
GCLKs and use those for baud-rate calculations.
This requires the GCLK to be part of the peripheral's config struct.
While this is already the case for most peripherals, this also adds
it for those where it wasn't used before.
As it defaults to 0 (CLOCK_CORECLOCK) no change is to be expected.
To simplify board definitions and for unification between samd2x and
newer models, don't use the GCLK bitmask in board definitions.
Instead use the GCLK index and generate the bitmask when needed.
This change is for all boards with a sam0 cpu. This cpu just has one ADC.
It is unnecessary to have defines with ADC_0_ prefix as if multiple ADCs
are possible.
Some defines were not used, such as ADC_0_EN, ADC_0_CHANNELS,
ADC_MAX_CHANNELS, ADC_0_CLK_SOURCE, ADC_0_CHANNELS
Change all ADC_0_ prefixes to ADC_
The currently supported SAM0 MCUs (samd21, saml21, saml1x) share the same
Timer peripheral, yet each of them carries it's own copy of the Timer
driver.
This introduces a new timer driver that is common for all sam0 MCUs and
uses structs for configuration instead of defines.
