When flashing multiple times the flasher gets stuck.
Default configuration is used that fixes running mulitple tests.
-c 'reset halt' is needed to support debug after config is changed.
For CI HIL purposes a reset is needed before running the test
target. The remote board didn't assign a RESET variable to perform
a reset, so it wasn't possible to call `make test` correctly.
By calling the flash script without arguments, a reset is performed.
iotlab-m3 boards always ended up not being able to flash after time.
This changes managed to fix and flash boards that where able to be flashed with
the deprecated `ft2232` driver and not with the `ftdi` driver used in RIOT.
It combines configuration from openocd, iot-lab, RIOT config and Alexandre
Abadie feedback
* http://repo.or.cz/openocd.git/blob/HEAD:/tcl/interface/ftdi/iotlab-usb.cfg
* ftdi configuration
* https://github.com/iot-lab/iot-lab-gateway/blob/2.4.1/gateway_code/static/iot-lab-m3.cfg
* `trst_and_srst` config
* Alexandre feedback and http://openocd.org/doc/html/Reset-Configuration.html
* 'connect_assert_srst' reset configuration
* it prevents errors in the output on first flash
* should help on boards with invalid code
* It was taken from what Alexandre found for board 'b-l072z-lrwan1'
* It requires using '-c reset halt' instead of '-c halt' before debug
* RIOT
* Keep the `configure -rtos` auto
- Use RIOT's GPIO interface to access the sensor to increase portability
- Changed API to allow more than one sensor per board
- Added `sht1x_params.h` that specifies how the sensors is connected - each
board can overwrite default settings by #defining SHT1X_PARAM_CLK and
SHT1X_PARAM_DATA
- Changed arithmetic to use integer calculations only instead of floating point
arithmetic
- Added support for checking the CRC sum
- Allow optional skipping of the CRC check to speed up measuring
- Added support for advanced features like reducing the resolution and skipping
calibration to speed up measuring
- Allow specifying the supply voltage of sensor which heavily influences the
temperature result (and use that information to calculate the correct
temperature)
- Reset sensor on initialization to bring it in a well known state
- Support for the obscure heater feature. (Can be useful to check the
temperature sensor?)
- Updated old SHT11 shell commands to the new driver interface, thus allowing
more than one SHT10/11/15 sensor to be used
- Added new shell command to allow full configuration of all attached SHT1x
sensors
- Removed old command for setting the SHT11 temperature offset, as this feature
is implemented in the new configuration command
The sensor family SHT10, SHT11 and SHT15 only differ in their accuracy (as in
calibration, not as in resolution). Thus, the same driver can be used for all.
The new driver name better reflects this fact.
Since wsn430-v1_3b and wsn430-v1_4 do have different radio
configurations we need to separate `board.h` for them, so this moves
their currently common `board.h` to `board_common.h` to be included by
later introduced `board.h`
