stm32mp1 is configuring gpio slightly differently that common stm32:
* port_num is computed differently, thus test MCU family to apply
the good calculation.
* Rising and falling edge state on interrupts. Do not test if falling
or rising edge, just launch the callback in all cases.
Signed-off-by: Gilles DOFFE <gilles.doffe@savoirfairelinux.com>
The reception code hands RX DMA descriptors back to the DMA right after its
contents were copied into the network stack internal buffer. This increases
the odds that the DMA never runs out of DMA descriptors to fill, even under
high load. However, the loop fetching the Ethernet frame stops to iterate at the
end of the frame. If the DMA used one more descriptor to store the FCS, this
was not returned back to the DMA. This commit fixes it.
Expose the auto-negotiation feature of the Ethernet device via the
pseudo-module stm32_eth_auto. With this enabled, the static speed configuration
set in the boards periph_conf.h will only be used if the PHY lacks
auto-negotiation capabilities - which is unlikely to ever happen.
Previously, only an link-up event was triggered, not an link down event. And
additionally, once the link-up event was sent, the link status was no longer
monitored. As a result, once a link-up was sent, no further link event were
triggered.
The methods to read from / write to MII registers had an address argument to
allow specifying the PHY to communicate with. However, only a single PHY is
available on all boards supported and the driver is not able to operate with
multiple PHYs anyway - thus, drop this parameter for ease of use.
This fixes a bug in the _get_link_status() function, which used hard coded the
address 0; which might not be correct for all boards.
The link status was previously not returned via the value parameter, as required
by the netdev_driver_t API. As a result, e.g. the `ifconfig` shell command
showed garbage.
Using the TER bit in the TX descriptors when only using a single descriptor for
sending triggered a hardware bug. Thus, stop using the TER bit and store the
currently active TX descriptor in RAM instead.
