This converts the hard-coded UART driver to the new ways.
- allow the board to configure the RX & TX pins
- allow for more than one UART
- allow setting the baudrate
- implement poweron()/poweroff() functions
Currently the cpu/lpc2387 init code hard-codes a 16 MHz
external oscillator.
Instead, calculate the PLL multiplier based on the board define
and also allow to run without an external oscillator.
At the time of configuration, the pthread-reaper uses '164' bytes of
stack when 'idle' stack is only '160'. By having double it gives some
margin.
ps
pid | name | state Q | pri | stack ( used) | base addr | current
1 | idle | pending Q | 15 | 160 ( 128) | 0x4000007c | 0x4000009c
2 | main | running Q | 7 | 2560 ( 1232) | 0x4000011c | 0x4000095c
3 | pthread-reaper | bl rx _ | 0 | 320 ( 164) | 0x40000bac | 0x40000c48
| SUM | | | 3040 ( 1524)
- Fixed documentation
- Use bitwise operation instead of multiplication and addition in `GPIO_PIN()`
- Allow GPIOs to be configured as input via `gpio_init()`
- Fixed bugs in `gpio_init_mux`:
- `0x01 << ((pin & 31) * 2)` was used before to generate the bitmask, but
this would shift by 62 to the left. Correct is `0x01 << ((pin & 15) * 2)`
(See [datasheet](https://www.nxp.com/docs/en/user-guide/UM10211.pdf) at
pages 156ff)
- Only one of the two bits was cleared previously
- Changed strategy to access GPIO pins:
- Previous strategy:
- Set all bits in FIOMASK except the one for the pin to control to
disable access to them
- Set/clear/read all pins in the target GPIO port (but access to all but
the target pin is ignored because of the applied FIOMASK)
- New strategy:
- Set/clear/read only the target pin
- Advantages:
- Only one access to a GPIO register instead of two
- Proven approach: Access to GPIOs on lpc2387 is mostly done by
accessing the GPIO registers directy (e.g. see the sht11 driver).
Those accesses never touch the FIOMASK register
- No unwanted side effects: Disabling all but one pin in a GPIO port
without undoing that seems not to be a good idea
- removed ISR_STACKSIZE define where unused (set to 0)
- removed thread_arch_isr_stack_usage(), thread_arch_isr_stack_start(),
and/or thread_arch_isr_stack_pointer() where not implemented
As discussed in #2725, this commit renames a number of stacksize constants to
better convey their intended usage. In addition, constants for thread priority
are given a `THREAD_` prefix. Changes are:
* KERNEL_CONF_STACKSIZE_PRINTF renamed to THREAD_EXTRA_STACKSIZE_PRINTF
* KERNEL_CONF_STACKSIZE_DEFAULT renamed to THREAD_STACKSIZE_DEFAULT
* KERNEL_CONF_STACKSIZE_IDLE renamed to THREAD_STACKSIZE_IDLE
* KERNEL_CONF_STACKSIZE_MAIN renamed to THREAD_STACKSIZE_MAIN
* Move thread stacksizes from kernel.h to thread.h, since the prefix changed
* PRIORITY_MIN renamed to THREAD_PRIORITY_MIN
* PRIORITY_IDLE renamed to THREAD_PRIORITY_IDLE
* PRIORITY_MAIN renamed to THREAD_PRIORITY_MAIN
* Move thread priorities from kernel.h to thread.h since the prefix has changed
* MINIMUM_STACK_SIZE renamed to THREAD_STACKSIZE_MINIMUM for consistency
