The esp8266 CPU has actually two hardware UART peripherals. UART0 is
used by the boot ROM for flashing and serial output during boot,
typically at a baudrate of 74880 bps until the bootloader or application
sets the more standard 115200 baudrate. This UART0 device has two
possible pins for TXD, GPIO1 and GPIO2, which are both set to TXD by the
boot ROM. esp8266 modules will typically have GPIO1 labeled as the TX
pin, but it is possible to use GPIO2 for that purpose even while
flashing the device with esptool.py.
The second device, UART1, also has two options for TXD, GPIO2 and GPIO7,
and only one option for RXD, GPIO8. However, GPIO7 and GPIO8 are used
by the flash internally so those options are not very useful unless
maybe while running from IRAM with the flash disabled, for example for
a debugger over UART1.
This patch allows boards to override UART{0,1}_{R,T}XD in their
periph_conf.h to configure the uart selection. Defining UART1_TX will
make the UART_DEV(1) device available.
Tested with:
```CFLAGS='-DUART1_TXD=GPIO2' make -C tests/periph_uart BOARD=esp8266-esp-12x flash term```
* Connected one USB-UART to the standard GPIO1 and GPIO3 for flashing
and console. After flashing we see the manual test output at 115200
bps
* Connected a second USB-UART with RX to GPIO2 running at 74880.
Then run on the first console:
```
> init 1 74880
> send 1 hello
```
The word "hello" appears on the second UART connection.
Note that GPIO2 is used during boot for UART0's TX until the application
or bootloader set it to a regular GPIO, so some boot ROM messages at
74880 bps are visible. After running `init 1 74880` it is set to UART1's
TX.
When the driver for the mpu9150 has been renamed to mpu9x50, the
corresponding macro in the MSB-IoT board was forgotten to be renamed
as well. This fixes the issue.
The periph_pm requires new field to control the power management
feature. Add missing config at periph_conf for timers and uart.
Signed-off-by: Gerson Fernando Budke <nandojve@gmail.com>
Add ATmega328P Xplained Mini board. The board is an official
development kit from MCHP based on the Arduino UNO, reduced
hardware, with a xplainedmini debugger and CDC ACM serial
converter.
Signed-off-by: Gerson Fernando Budke <nandojve@gmail.com>
This board is based on rak4260 with rak specific pinmappings.
ADC, LED and UART as well as USB ist supposed to work.
Mostly adopted from SAM R34 Xplained Pro board with adoption to rak pinout.
