If a node has two interfaces A with 2001:16b8:45b5:9af8:5884:3bff:fe4f:a903
and B with 2001:16b8:45b5:9afa:5884:3bff:fe4f:a902 and receives a neighbor
solicitation on A for an address configured on interface B, answer the neighbor
solicitation instead of bailing out with
> Target address 2001:16b8:45b5:9afa:5884:3bff:fe4f:a902 is not assigned
> to the local interface
Make gnrc_netif_create() block until the interface is created and
registered.
This avoids a race condition where after calling gnrc_netif_init_devs()
not all interfaces are available yet when iterating through the list
of interfaces with gnrc_netif_iter().
A lot of things break if `GNRC_NETIF_FLAGS_HAS_L2ADDR` is not set.
In order to handle router advertisements and auto-configureation,
generate a faux l2 address based on the netdev ID.
As support grows we need a cleaner way of enforcing kconfig testing.
This checks an app contains an app.test.config for a supported board.
This removes the need to list idividual tests.
Groups can still be enforced with the TEST_KCONFIG_ENFORCE_APP_GROUPS.
If a board is in TEST_KCONFIG_BOARDS_AVAILABLE, all supported apps should be built.
This commit fixes the send function of sx126x. The loop that reads the
iolist was not considering the offset. Therefore each iolist snippet was
being written into the first position.
The loop was also setting the payload length to the size of the iolist
snippet. Then the payload was also wrong.
With this commit an iolist is copied sequentially into the framebuffer
and the payload length is set to `iolist_size`
This option was unused before, honor it to make it possible to start
with router advertisements disabled and enable them at run time.
The defaults remain unchanged by that.
Some BOARD terminals are slow to start so if the BOARD is reset after
opening the terminal this can lead to off-by-one error when parsing
the output.
So instead do as testrunner and reset before opening the terminal.
Note that no interactive_sync is needed since a similar mechanism
happens in ShellInteraction.
Some BOARD terminals are slow to start so if the BOARD is reset after
opening the terminal this can lead to off-by-one error when parsing
the output.
So instead do as testrunner and reset before opening the terminal.
Note that no interactive_sync is needed since a similar mechanism
happens in ShellInteraction.
