This allows to set a timer between the completion of a datagram in the
reassembly buffer and the deletion of the corresponding reassembly
buffer entry. This allows to ignore potentially late incoming link-layer
duplicates of fragments of the datagram that then will have the
reassembly buffer entry be blocked.
This was noted in this [discussion] for classic 6LoWPAN reassembly (and
minimal fragment forwarding) and is recommended in the current
[selective fragment recovery draft][SFR draft].
[discussion]: https://mailarchive.ietf.org/arch/msg/6lo/Ez0tzZDqawVn6AFhYzAFWUOtJns
[SFR draft]: https://tools.ietf.org/html/draft-ietf-6lo-fragment-recovery-07#section-6
Currently the cpu/lpc2387 init code hard-codes a 16 MHz
external oscillator.
Instead, calculate the PLL multiplier based on the board define
and also allow to run without an external oscillator.
Scan-build detected that sercom_id could return -1 and the value of this function is affected to uint8_t variables. Since these variables are used for shitfing bit in registers, this could lead to undefined behavior
Clean up `default-channel.inc.mk` to only set the custom CFLAGS
if they are really needed.
This should help avoid cluttering `riotbuild.h`.
The default PAN ID configuration should be just as easy to set
as the default channel, so also add an option for that while we
are at it.
On ESP32 and new ESP8266 platform, the compilation of the package fails since a local variable is potentially used uninitialized. Therefore, the variable is initialized with a default value.
The ATmega128RFA1 and ATmega256RFR2 contain a version of this IP
on the MCU.
The radio core behaves mostly like a at86rf231, but all registers
are mapped to memory and radio states can directly generate interrupts
on the CPU.
The ATmega256RFR2 adds support for automatic retransmissions.
This has not been implemented yet.
Co-authored-by: Josua Arndt <jarndt@ias.rwth-aachen.de>
Fix the condition to return -ENOPNOTSUPP when i2c repeated read attempted.
Currently the error occures even if a read after write is attempted.
This is the standard way to i2c_read_reg which should be supported.
The -EOPNOTSUPP requires the previous R/W state to be reading.
This means a `I2C_SR2_TRA` must be checked to be 0.
There is no hardware limitation for custom boards based on STM32 to uses
SPI bus with signals coming from different PORT and alternate functions.
This patch allow alternate's function definition per pin basis, thus enable
the support of SPI bus signals routed on differents PORT.
Signed-off-by: Yannick Gicquel <ygicquel@gmail.com>
Added a script to determine the sizes of the default C11 atomic types and
generate an C++ header with preprocessor defines to access the sizes of the
types and an integer type of the same size (and therefore alignment
requirements).
Added a header to allow defining C interfaces using the default C11 atomic
types. Those types are however fully opaque and inaccessible from C++, as C11
atomics are completely incompatible with C++.
