The MSP430 vendor files already provide macros containing register
constants and symbols (provided via linker scripts) containing addresses
of peripheral registers. So lets make use of that rather than
maintaining a long list of constants.
RIOT supports two distinct families of the MSP430: The [MSP430 x1xx]
MCU family and the [MSP430 F2xx/G2xx] MCU family. For both incompatible
MCU families the code was located in the msp430fxyz folder, resulting
in case of the UART driver in particularly bizarre code looking roughly
like this:
#ifndef UART_USE_USCI
/* implementation of x1xx peripheral ... */
#else
/* implementation of F2xx/G2xx peripheral ... */
#endif
/* zero shared code between both variants */
This splits the peripheral drivers for USCI and USART serial IP blocks
into separate files and relocates everything in cpu/msp430, similar to
how cpu/stm32 is organized.
[MSP430 x1xx]: https://www.ti.com/lit/ug/slau049f/slau049f.pdf
[MSP430 F2xx/G2xx]: https://www.ti.com/lit/ug/slau144k/slau144k.pdf
Provide a common clock initialization driver rather than leaving
clock initialization to the boards code. A declarative description of
the board's clock configuration using a struct does still allow to
fine-tune settings. In addition, a board is still allowed to just
provide a custom `void clock_init(void)` if there really is the need
to do crazy things.
- most were trivial
- missing group close or open
- extra space
- no doxygen comment
- name commad might open an implicit group
this hould also be implicit cosed but does not happen somtimes
- crazy: internal declared groups have to be closed internal
The file always exist so no need to do '-include'.
Replaced using:
sed -i 's|-\(include $(RIOTCPU)/.*/Makefile.features\)|\1|' \
$(git grep -l '$(RIOTCPU)/.*/Makefile.features' boards)
- Use RIOT's GPIO interface to access the sensor to increase portability
- Changed API to allow more than one sensor per board
- Added `sht1x_params.h` that specifies how the sensors is connected - each
board can overwrite default settings by #defining SHT1X_PARAM_CLK and
SHT1X_PARAM_DATA
- Changed arithmetic to use integer calculations only instead of floating point
arithmetic
- Added support for checking the CRC sum
- Allow optional skipping of the CRC check to speed up measuring
- Added support for advanced features like reducing the resolution and skipping
calibration to speed up measuring
- Allow specifying the supply voltage of sensor which heavily influences the
temperature result (and use that information to calculate the correct
temperature)
- Reset sensor on initialization to bring it in a well known state
- Support for the obscure heater feature. (Can be useful to check the
temperature sensor?)
- Updated old SHT11 shell commands to the new driver interface, thus allowing
more than one SHT10/11/15 sensor to be used
- Added new shell command to allow full configuration of all attached SHT1x
sensors
- Removed old command for setting the SHT11 temperature offset, as this feature
is implemented in the new configuration command
