As stm32mp1 family accesses gpio pins with a different
offset than other stm32, create a specific macro.
Signed-off-by: Gilles DOFFE <gilles.doffe@savoirfairelinux.com>
* Setup i2c speed to I2C_SPEED_LOW by default
* enable i2c_write_regs() function.
* i2c frequency needs to be specified into board periph_conf.h
Signed-off-by: Gilles DOFFE <gilles.doffe@savoirfairelinux.com>
This adds a placeholder define for when the DMA peripheral available on
the MCU doesn't support channel/trigger filtering. This is the case on
the stm32f1 and stm32f3 family.
The stm32_eth driver was build on top of the internal API periph_eth, which
was unused anywhere. (Additionally, with two obscure exceptions, no functions
where declared in headers, making them pretty hard to use anyway.)
The separation of the driver into two layers incurs overhead, but does not
result in cleaner structure or reuse of code. Thus, this artificial separation
was dropped.
If any incoming frame is bigger than a single DMA buffer, the Ethernet DMA will
split the content and use multiple DMA buffers instead. But only the DMA
descriptor of the last Ethernet frame segment will contain the frame length.
Previously, the frame length calculation, reassembly of the frame, and the
freeing of DMA descriptors was completely broken and only worked in case the
received frame was small enough to fit into one DMA buffer. This is now fixed,
so that smaller DMA buffers can safely be used now.
Additionally the interface was simplified: Previously two receive flavors were
implemented, with only one ever being used. None of those function was
public due to missing declarations in headers. The unused interface was
dropped and the remaining was streamlined to better fit the use case.
- Add missing `volatile` to DMA descriptor, as memory is also accessed by the
DMA without knowledge of the compiler
- Dropped `__attribute__((packed))` from DMA descriptor
- The DMA descriptor fields need to be aligned on word boundries to
properly function
- The compiler can now more efficiently access the fields (safes ~300 B ROM)
- Moved the DMA descriptor struct and the flags to `periph_cpu.h`
- This allows Doxygen documentation being build for it
- Those types and fields are needed for a future PTP implementation
- Renamed DMA descriptor flags
- They now reflect to which field in the DMA descriptor they refer to, so
that confusion is avoided
- Added documentation to the DMA descriptor and the corresponding flags
The available GPIO ports may also differ within a family. Therefore, the vendor definitions GPIO* are used instad of CPU_FAM_STM definitions to determine which ports are available for a certain MCU.
The STM32 line of microcontrollers comes with a bootloader in the ROM.
It provides the option to flash the device firmware in DFU mode (USB)
or via UART or SPI.
To enter the bootloader we have to jump to a specific address in memory,
but before reset the CPU to make sure the system is in a known state.
This enables us to use the usb_board_reset module on all STM32 platforms.
This commit adds two new functions to the DMA peripheral code for the
stm32. The setup function allows for a one-time setup of peripheral
config. The prepare function does the per-transfer setup. This allows
for a single setup call during the peripheral lock step and a
per-transfer call to the prepare function.
`usbdev_stm32.h` will pull in `usb.h` which causes an error if
`USB_H_USER_IS_RIOT_INTERNAL` is not set.
Turns out this include is not needed, so just drop it.
