In RIOT native, sending CTRL+D to a shell started using shell_run would resulted in and
endless prompt loop. I've been unable to trigger such a behaviour
on actual hardware using a UART connection, but calling `pm_off` seemed
like a better alternative than having an `#ifdef BOARD_NATIVE`.
Fixes#9946
This updates the ccn-lite package version which brings in the
latest upstream fixes for some compiler issues found on macOS
with clang and newer GCC versions.
A minor adaption of the RIOT shell commands is also included.
When compiled for `hifive1` board with `gcc-7.2.0` this warning was raised:
'ret' may be used uninitialized in this function [-Werror=maybe-uninitialized]
- Use RIOT's GPIO interface to access the sensor to increase portability
- Changed API to allow more than one sensor per board
- Added `sht1x_params.h` that specifies how the sensors is connected - each
board can overwrite default settings by #defining SHT1X_PARAM_CLK and
SHT1X_PARAM_DATA
- Changed arithmetic to use integer calculations only instead of floating point
arithmetic
- Added support for checking the CRC sum
- Allow optional skipping of the CRC check to speed up measuring
- Added support for advanced features like reducing the resolution and skipping
calibration to speed up measuring
- Allow specifying the supply voltage of sensor which heavily influences the
temperature result (and use that information to calculate the correct
temperature)
- Reset sensor on initialization to bring it in a well known state
- Support for the obscure heater feature. (Can be useful to check the
temperature sensor?)
- Updated old SHT11 shell commands to the new driver interface, thus allowing
more than one SHT10/11/15 sensor to be used
- Added new shell command to allow full configuration of all attached SHT1x
sensors
- Removed old command for setting the SHT11 temperature offset, as this feature
is implemented in the new configuration command
The sensor family SHT10, SHT11 and SHT15 only differ in their accuracy (as in
calibration, not as in resolution). Thus, the same driver can be used for all.
The new driver name better reflects this fact.
I'm using something like this command for a while now for debugging
GNRC. Usually, I just patch it into the application I'm using it with,
but I think there is a benefit to also provide it to RIOT upstream
properly.
