Some periph_rtt implementations do not provide `rtt_set_counter()`. This
adds `periph_rtt_set_counter` as feature to allow testing for its
availability. The feature is provided at CPU level if periph_rtt is
provided by the board for all CPUs implementing `rtt_set_counter()`.
Some periph_rtt implementations do not provide `rtt_set_counter()`. This
adds `periph_rtt_set_counter` as feature to allow testing for its
availability. The feature is provided at CPU level if periph_rtt is
provided by the board for all CPUs implementing `rtt_set_counter()`.
- Adds capabilities for each PHY mode. Converts the uint16_t caps field to an
uint32_t in order to hold all capability bits, size of the structure remains
unchanged due to alignment.
- Modifies the test application to configure the PHY mode using the shell
command. Also adds the PHY modes to the capabilities shell command.
- Updates the nrf802154 and cc2538 radio drivers to specify the PHY mode
supported.
Signed-off-by: Jean Pierre Dudey <me@jeandudey.tech>
If there is an event to be handled by _esp_eth_isr(), don't
overwrite it if a new packet has been received.
In my testing, all SYSTEM_EVENT_ETH_CONNECTED events except the first
are immediately followed by at least one SYSTEM_EVENT_ETH_RX_DONE event.
This causes the SYSTEM_EVENT_ETH_CONNECTED to not get handled, and the
IP stack will not be notified of the new link state.
Protect the other events by dropping the packet instead. If an earlier
unhandled SYSTEM_EVENT_ETH_RX_DONE event exists, overwrite it with the
newer packet.
I only saw this happen with lwIP and not with GNRC - I am not sure why.
But it still is a race waiting to happen. The nice long term solution
is probably to have a queue of unhandled events, allowing them all to
be processed once there is time.
The ADC SYNCBUSY.SWTRIG gets stuck to '1' after wake-up from Standby Sleep mode.
Ignore the ADC `SYNCBUSY.SWTRIG` status bit, this functionality is not used by
the driver anyway.
The global core/ldscripts/xfa.ld doesn't match our cortexm_base.ld.
This commit directly adds the two XFA lines to cortexm_base.ld.
In addition to that, a dummy (empty) xfa.ld is added, which the linker will pick
instead of core/ldscripts/xfa.ld, effectingly not using it.
nRF52833 has POWER_MAINREGSTATUS_MAINREGSTATUS_High, but no POWER->DCDCEN0
register.
This breaks all builds on this MCU.
Fix the ifdef to fix the build.
