openocd configuration file for `stm32f7` relies on probing to find out
FLASH_ADDR. On nucleo-f767zi board probing (`flash probe 0`) fails when
`srst` is asserted, but `srst` needs to be asserted to be able to flash
the `BOARD` when sleeping or after a hardfault.
To circumvent this in boards/common/stm32/dist/stm32f7.cfg we define a new
flash bank with the appropriate fash start address and specify that this is
the flash bank to be used as default configuration instead of the
default by setting FLASH_BANK=4
With the new toolchain version required to fix issue #13133, the compilation of `examples/posix_socket` fails due to a C linkage error in `atomic_base.h`. The reason is that including `drivers/include/mtd.h` in `boards/esp32/board_common.h` inside the `extern C` block finally leads to including `atomic_base.h` inside the `extern C` block which in turn to the C linkage error for the template definitions in this file.
GCC now warns when snprintf()ing a buffer that, together with the
format string, might be larger than the destination buffer.
To fix this increase the size of the destination buffer so that
the source buffer and the format string will always fit - 32 bytes
are enough.
`led_init()` is already protected by an `#ifdef`, so no need for
the weak symbol.
The problem is that the weak function does not get overridden, even when
the board provides it's own led_init(), resulting in no LEDs being
initialized.
The setter function approach makes this switchable at runtime (antenna
diversity?).
Documentation is added both to the board introduction page and the
individual pins and functions.
The particle-{argon,boron,xenon} all have a uFL connector and a PCB
antenna for 2.4GHz radio, connected by a SKY13351-378LF switch
configured by a VCTL[12] pin pair.
This sets the default configuration to use the PCB antenna, as driving
an unconnected antenna will deteriorate radio performance.
The 'msba2' common files have accumulated many empty files are files that
do nothing.
This makes reasoning about the boards needlessly difficult.
Trim down on `common/msba2/` so that it now only contains the setup for the
UART/bootloader based flashing.
This should eventuelly be moved to `makefiles/tools/`
- Move serial.inc.mk in remote and openmote-b Makefile.include before
PROG_DEV to avoid repeating OS logic check
- Add deprecation warning for PORT_BSL
