The driver uses the netdev interface. Due to the limited
capabilities of the transceiver (32 byte FIFO and no source address in the layer2 frame),
it relies on 6LowPAN compression and adds the source address to the frame for that.
In Engineering mode (BOOT0 off and BOOT2 on), only the Cortex-M4
core is running. It means that all clocks have to be setup
by the Cortex-M4 core.
In other modes, the clocks are setup by the Cortex-A7 and then should
not be setup by Cortex-M4.
stm32mp1_eng_mode pseudomodule have to be used in Engineering mode
to ensure clocks configuration with IS_USED(MODULE_STM32MP1_ENG_MODE)
macro.
This macro can also be used in periph_conf.h to define clock source
for each peripheral.
Signed-off-by: Gilles DOFFE <gilles.doffe@savoirfairelinux.com>
Expose the auto-negotiation feature of the Ethernet device via the
pseudo-module stm32_eth_auto. With this enabled, the static speed configuration
set in the boards periph_conf.h will only be used if the PHY lacks
auto-negotiation capabilities - which is unlikely to ever happen.
In analogy to the existing GPIO mappings, this provides (write-only)
SAUL entries for PWM'd LEDs in a single-LED (as SAUL_ACT_DIMMER) and an
RGB (as SAUL_ACT_RGB_LED) mode.
Co-authored-by: Marian Buschsieweke <marian.buschsieweke@ovgu.de>
This commit introduces a common storage backend for SUIT manifest
payloads. Different backends can be compiled into a single firmware.
Degending on the component name in the SUIT manifest, a storage backend
is selected by the parser.
It has no real purpose other than pulling in `gnrc_ipv6_router` as a
dependency, which is already done in other places (or by pulling in its
dependencies).
Support for picolibc as alternative libc implementation is added with
this commit. For now only cortex-m CPU's are supported.
Enable via PICOLIBC=1
---
v2:
squash fixes in
v3:
Remove picolibc integer printf/scanf stuff from sys/Makefile.include,
it gets set in makefiles/libc/picolibc.mk
fixup for dependency
It is desireable to have a way to identify network devices.
This should be independent from the type of netdev, so a common identifier is needed.
Base this on the driver ID and the index in the configuration struct.
This way we achive unique IDs that stay consistent for any firmware flashed on a board.
The stm32_eth driver was build on top of the internal API periph_eth, which
was unused anywhere. (Additionally, with two obscure exceptions, no functions
where declared in headers, making them pretty hard to use anyway.)
The separation of the driver into two layers incurs overhead, but does not
result in cleaner structure or reuse of code. Thus, this artificial separation
was dropped.
