The Silicon Labs Si705x sensors (Si7050/1/3/4/5) are very similar to the
Si7021 sensors featuring only a temperature sensor and no humidity
sensor. The only difference between the Si705x is the temperature
accuracy of the reading, ranging from +/- 0.1 C in the Si7051 to +/- 1 C
in the Si7050.
This patch adds support for this family of sensors extending the
functionality of the existing si70xx driver. Following the style of
other modules, this implements a pseudomodule per supported chip, adding
si7050, si7051, si7053, si7054 and si7055 pseudomodules.
As a minor change this patch also implements the missing
si70xx_get_serial, si70xx_get_id and si70xx_get_revision functions that
were declared in the si70xx.h header but implemented as private
functions. The si70xx_get_id() may be relevant for the application to
know at run time exactly which version of the hardware is installed.
The updated test running with a Si7051 shows the following output, which
seems consistent with the room temperature conditions during the test.
```
make SI70XX_VARIANT=si7051 -C tests/driver_si70xx/ all flash
```
```
SI70XX temperature and humidity sensor test application
Initializing sensor...
[OK]
Found SI7051 sensor, revision 32
temperature: 24.71 C
temperature: 24.69 C
```
tests/driver_ds3231
drivers/ds3231: add alarm support with IRQ
drivers/ds3231: alarm support and documentation
drivers/ds3231: alarm interrupt with mutex
drivers/ds3231: alarm, _unlock function
fixup! drivers/ds3231: add alarm support
The driver uses the netdev interface. Due to the limited
capabilities of the transceiver (32 byte FIFO and no source address in the layer2 frame),
it relies on 6LowPAN compression and adds the source address to the frame for that.
In Engineering mode (BOOT0 off and BOOT2 on), only the Cortex-M4
core is running. It means that all clocks have to be setup
by the Cortex-M4 core.
In other modes, the clocks are setup by the Cortex-A7 and then should
not be setup by Cortex-M4.
stm32mp1_eng_mode pseudomodule have to be used in Engineering mode
to ensure clocks configuration with IS_USED(MODULE_STM32MP1_ENG_MODE)
macro.
This macro can also be used in periph_conf.h to define clock source
for each peripheral.
Signed-off-by: Gilles DOFFE <gilles.doffe@savoirfairelinux.com>
Expose the auto-negotiation feature of the Ethernet device via the
pseudo-module stm32_eth_auto. With this enabled, the static speed configuration
set in the boards periph_conf.h will only be used if the PHY lacks
auto-negotiation capabilities - which is unlikely to ever happen.
In analogy to the existing GPIO mappings, this provides (write-only)
SAUL entries for PWM'd LEDs in a single-LED (as SAUL_ACT_DIMMER) and an
RGB (as SAUL_ACT_RGB_LED) mode.
Co-authored-by: Marian Buschsieweke <marian.buschsieweke@ovgu.de>
This commit introduces a common storage backend for SUIT manifest
payloads. Different backends can be compiled into a single firmware.
Degending on the component name in the SUIT manifest, a storage backend
is selected by the parser.
