Martine Lenders
70c970695a
tests/gnrc_ipv6_ext: port to scapy
2019-01-11 13:27:21 +01:00
Kevin "Bear Puncher" Weiss
d9f26dbbe2
Merge pull request #10636 from aabadie/pr/cpu/nrf5x_gpio_common
...
cpu/nrf5x: move periph_gpio/periph_gpio_irq at an even more common level
2019-01-03 11:37:48 +01:00
Kevin "Bear Puncher" Weiss
e4ed9d703d
Merge pull request #10118 from aabadie/pr/tests/sx127x_default_board
...
tests/sx127x: set b-l072z-lrwan1 as default board
2019-01-03 11:35:49 +01:00
0d4b55e0c8
Merge pull request #10654 from keestux/driver-rn2xx3-rx1delay
...
loramac: change rxdelay1 to millisec, was seconds
2019-01-03 11:24:17 +01:00
0ca4703dde
Merge pull request #10687 from kb2ma/nanocoap/remove_macro
...
net/nanocoap: remove obsolete macro
2019-01-03 11:00:52 +01:00
José Alamos
f14d46d935
Merge pull request #10242 from miri64/gnrc_ipv6_ext_rh/enh/icmpv6_error_msg
...
gnrc_ipv6_ext_rh: add ICMPv6 error message sending
2019-01-03 10:35:54 +01:00
Kevin "Bear Puncher" Weiss
2bf29dd99e
Merge pull request #10692 from aabadie/pr/boards/nucleo-f767_i2c
...
boards/nucleo-f767zi: use common STM32 i2c configuration
2019-01-03 10:17:44 +01:00
552909cf90
Merge pull request #10694 from MrKevinWeiss/pr/bh1750fix
...
drivers/bh1750: Fix mislabeled i2c address
2019-01-03 09:50:56 +01:00
Kevin "Bear Puncher" Weiss
fd15cb8f77
Merge pull request #10646 from aabadie/pr/boards/nucleo-f072-i2c
...
boards/nucleo-f072rb: configure I2C using common stm32 configuration
2019-01-03 09:48:57 +01:00
MrKevinWeiss
b870dbb3b9
drivers/bh1750: Fix mislabeled i2c address
...
The i2c address when the pin is high/low are swapped.
This swaps them to match the datasheet and changes the default to low.
2019-01-03 09:08:31 +01:00
Kevin "Bear Puncher" Weiss
90b5865692
Merge pull request #10691 from aabadie/pr/boards/stm32_useless_defines
...
boards/stm32: remove useless empty conf defines
2019-01-02 17:00:30 +01:00
c0b1d37d73
boards/nucleo-f072rb: use common i2c configuration
2019-01-02 16:08:56 +01:00
f6985c5b31
cpu/stm32f0: update stm32f072xb CMSIS header
2019-01-02 16:08:56 +01:00
402f02d471
boards/nucleo-f767zi: use STM32 common i2c config
2019-01-02 16:06:34 +01:00
9a61febf5c
cpu/stm32f7: update stm32f767zi cmsis header file
2019-01-02 16:06:34 +01:00
Kevin "Bear Puncher" Weiss
24837e9f17
Merge pull request #10690 from aabadie/pr/boards/stm32_common_i2c_f0_f2
...
boards/stm32: factorize i2c configuration on stm32f0 and stm32f2 based nucleo boards
2019-01-02 16:05:36 +01:00
Kevin "Bear Puncher" Weiss
5fd304b5f5
Merge pull request #10588 from aabadie/pr/tests/bench_coreapis_pexpect_fix
...
tests/bench_runtime_coreapis: improve pexpect autotest
2019-01-02 15:06:51 +01:00
9a69c9bbc5
boards/stm32: remove useless empty conf defines
2019-01-02 14:52:38 +01:00
3eba44a660
boards/nucleo-f0207zg: use common clock and i2c configuration
2019-01-02 14:29:26 +01:00
24bc5ae254
boards/nucleo-f0xx: use common i2c configuration
2019-01-02 14:23:46 +01:00
541fc7f93f
boards/stm32: add f2 common clock configuration
2019-01-02 14:23:46 +01:00
f90c69cf6e
tests/bench_runtime_coreapis: improve pexpect autotest
2019-01-02 14:22:37 +01:00
4e7bfb65df
tests/bench_runtime_coreapis: globally import testrunner
2019-01-02 14:22:28 +01:00
Kevin "Bear Puncher" Weiss
02ec3845de
Merge pull request #9728 from aabadie/pr/boards/stm32_common_i2c
...
boards: factorize some nucleo f4/f7/l4 i2c configuration
2019-01-02 14:05:32 +01:00
536e4a55a8
boards/nucleo-l496zg: provide and configure i2c
2019-01-02 11:27:42 +01:00
ed6dcfe872
boards/nucleo-f746zg: provide and configure i2c
2019-01-02 11:27:25 +01:00
4fd4ce4c54
boards/nucleo-f722/l476: use common i2c configuration
2019-01-02 11:26:54 +01:00
f8d8ddb1ef
boards/stm32: adapt common i2c config to f7 and l4
2019-01-02 11:25:32 +01:00
0d6af64a15
Merge pull request #10647 from aabadie/pr/boards/nucleo-l422rc-i2c
...
boards/nucleo-l433rc: add I2C configuration
2019-01-02 11:01:17 +01:00
b81941f953
boards/nucleo-f4**: use common clock and I2c configuration
2019-01-02 10:30:13 +01:00
08608c350c
boards/stm32: add common I2C configuration
...
This configuration provides 1 I2C using I2C1 on PB8 and PB9, which is very common for STMs
2019-01-02 10:30:13 +01:00
11da5036fb
boards/stm32: add new common clock configurations
2019-01-02 10:30:13 +01:00
824201b9ea
boards/nucleo-l433rc: add I2C configuration
2019-01-02 10:19:46 +01:00
Kevin "Bear Puncher" Weiss
7f179cd0bf
Merge pull request #10689 from aabadie/pr/boards/st_adc_numof_cleanup
...
boards/stm32: remove unnecessary ADC defines in board config
2019-01-02 10:10:29 +01:00
973a6a4c93
boards/stm32: remove unnecessary ADC defines in board config
2019-01-02 09:15:22 +01:00
Ken Bannister
c17cf650ca
net/nanocoap: remove obsolete macro
2018-12-31 07:17:29 -05:00
Gunar Schorcht
d3f78a5a40
Merge pull request #10679 from miri64/gnrc_sixlowpan_frag/fix/send-check-msg-queue
...
gnrc_sixlowpan_frag: check if own message queue is full
2018-12-30 15:48:26 +01:00
Gunar Schorcht
934c4225d2
Merge pull request #10680 from miri64/gnrc_sixlowpan_frag/fix/rbuf-full-release
...
gnrc_sixlowpan_frag: release packet rbuf_add error cases
2018-12-30 15:47:59 +01:00
Martine Lenders
e8da744e6d
gnrc_sixlowpan_frag: release packet when frag hdr can't be marked
...
Otherwise, there will be leaks ;-).
2018-12-30 01:05:34 +01:00
Martine Lenders
a409603f84
gnrc_sixlowpan_frag: release packet when rbuf is full
...
Otherwise, there will be leaks ;-).
2018-12-30 00:59:04 +01:00
Martine Lenders
9e3cdebae1
gnrc_sixlowpan_frag: check if own message queue is full
...
When issueing the sending of the next fragment the current version of
`gnrc_sixlowpan_frag` doesn't check if the queue is full. This leads to
leakage of the packet buffer, since when it is full, the package never
gets released.
This change adds a checks and error exits in case the queue is full.
2018-12-29 22:54:52 +01:00
Martine Lenders
d5bbf45d32
gnrc_sixlowpan_frag: reduce code duplication in send
2018-12-29 22:54:14 +01:00
Gunar Schorcht
a87c2c9563
Merge pull request #10675 from miri64/dist/enh/print-toolchain-version-xtensa
...
print_toolchain_versions.sh: add xtensa toolchains
2018-12-29 15:44:44 +01:00
Martine Lenders
4887b22ef5
print_toolchain_versions.sh: add xtensa newlibs
2018-12-29 15:26:36 +01:00
Martine Lenders
fa3d617e2e
Merge pull request #10657 from maribu/netdev_driver_pre
...
netdev_driver_t::recv(): Clarified documentation
2018-12-29 14:34:42 +01:00
Martine Lenders
745574266c
print_toolchain_versions.sh: add xtensa toolchains
2018-12-29 14:28:08 +01:00
Martine Lenders
7bdbd163c9
print_toolchain_versions.sh: make lists easily diff-able
2018-12-29 14:27:35 +01:00
Martine Lenders
5dda85f54d
Merge pull request #10581 from TimoRoth/master
...
esp_now: avoid parsing IPv6 header in netdev driver
2018-12-29 14:08:38 +01:00
Marian Buschsieweke
58f496de47
netdev_driver_t::recv: Extend doc on size feature
...
Some drivers return on netdev_driver_t::recv() not the actual frame size, but
an upper bound estimation of it. The upper layer code is already prepared to
handle that. This brings the doc in sync with the code.
2018-12-29 13:59:58 +01:00
Timo Rothenpieler
814e4ecbbe
gnrc_netif: ESP-NOW talks 6Lo now
2018-12-29 13:15:44 +01:00
