Avoids parsing IPv6 packets to determine destination address.
Allows using 6Lo over ESP-NOW, which is required due to the low MTU of
ESP-NOW.
Co-authored-by: Gunar Schorcht <gunar@schorcht.net>
Refactors i2c_2 to match the structure of i2c_1 better.
Corrects functionality issues.
Allows the common implementation of read_regs and write_regs.
Documents constraints of hardware.
Matches error messages with API.
RIOTBOOT_SLOT_LEN is calculated as an hexadecimal value and
handles ROM_LEN defined as kilobytes like '512K'
This enables support for all the cortex-m0+/3/4/7 arch,
so most boards embedding these are potentially supported.
One needs just to ensure that the CPU can be initialised
at least twice.
Co-authored-by: Gaëtan Harter <gaetan.harter@fu-berlin.de>
This new function allows to jump to another execution
environment (VTOR) located at a certain (aligned) address.
It's used to boot firmwares at another location than
`CPU_FLASH_BASE`.
The user needs to ensure that the CPU using this feature
is able to be initialised at least twice while jumping
to the RIOT `reset_handler_default` function, since it
initialises the CPU again (calls cpu_init()).
Co-authored-by: Kaspar Schleiser <kaspar@schleiser.de>
Due to the stdio getting called after periph_init the uart may send before initialized.
This adds a simple check so the uart does not get into a locked-up state.
This commit fixes configuration problems when trying to use i2c pins that need to be remapped.
All B8 and B9 pins for STM32F1 need to be remapped, so a check is done if the remappable pins are selected.
cpu/esp32/include/periph_cpu.h overrides the default definition of adc_res_t from periph/adc with a definition which contains only four resolution, two new resolutions and two resolutions defined by the default definition of adc_res_t. This gives compilation errors if an application uses other resolutions. According to the documentation, adc_sample should return -1 if the resolution is not supported. All other CPUs override adc_res_t either to add new resolutions or to mark resolutions as unsupported. But they all allow to use them at the interface. Therefore, esp32 overrides now the definition of adc_res_t with all resolutions that are defined by the default definition of adc_res_t and new platform specific resolutions. It returns -1 if a resolution is used in adc_sample that is not supported.
cpu/esp8266/include/periph_cpu.h overrides the default definition of adc_res_t from periph/adc with a definition which contains only one resolution. This gives compilation errorss if an application uses other resolutions. According to the documentation, adc_sample should return -1 if the resolution is not supported. All other CPUs override adc_res_t either to add new resolutions or to mark resolutions as unsupported. But they all allow to use them at the interface. Therefore, esp8266 uses now the default definition of adc_res_t and returns -1 if a solution is used in adc_sample that is not supported.
By not forcing a fixed oversampling rate we can achieve better baud rate
accuracy than otherwise possible.
For example, when requesting 115200 with a module clock of 4 MHz,
picking an oversampling rate of 17 (instead of hardware
default 16) yields 117647 baud instead of 125000 baud as the best
matching rate. Better matching baud rate between receiver and
transmitter results in a lower probability of transmission errors.
- correct number of timers for atmega328p from 2 to 1
- correct number of timer channels for atmega328p from 3 to 2
- adapt atmega periph timer implementation accordingly
