Fix compilation with module `stm32_eth_link_up` when `stm32_eth_auto`
is not used by relying on the compiler to optimize unused functions
and variables out, rather than using the preprocessor.
- Clear the PTP timer interrupt *after* the user callback is executed
- Otherwise it would be possible that the ISR sets another super
short timeout that triggers during ISR, which also gets cleared
- This is a pretty nasty race condition :-/
- The debug output was a bit too verbose to be generally useful. Some
noise is now silenced unless `DEBUG_VERBOSE` is `#define`d to 1
Deep-sleep was based on using rx pin as external interrupt to be able to
wake up from stop mode. If rx pin cannot be used as interrupt or user
does not need to wake up from stop from the CAN, an option is now
present. If en_deep_sleep_wake_up is set to false, setting the device to
sleep simply unblock stop mode. Otherwise the behavior is unchanged.
In case a non-gpio EXTI (>= 16) is pending, the isr_exti() used to clear
the flag and try to call a callback, which was out-of-bouds, thus
generating a hard fault.
This fixes it by masking the pending_isr variables with 0xFFFF.
Add ENABLE_DEBUG_VERBOSE flag, so that the noise during debugging can be
reduced. This is super helpful when testing under load, as otherwise there is
just too much noise in the output.
An earlier version of periph_eth used to always pack the first chunk of the
outgoing frame to the first DMA descriptor by telling the DMA to jump back
to the first descriptor within the last descriptor. This worked fine unless
the frame was send in one chunk (as e.g. lwip does), which resulted due to a
hardware bug in a frame being send out twice. For that reason, the behavior was
changed to cycle throw the linked DMA descriptor list in round-robin fashion.
However, the error checking was not updated accordingly. Hence, the error
check might run over (parts of) unrelated frames and fail to detect errors
correctly.
This commit fixes the issue and also provides proper return codes for errors.
Additionally, an DMA reset is performed on detected errors during RX/TX. I'm
not sure if/when this is needed, as error conditions are neigh impossible to
produce. But better be safe than sorry.
This commits adds a common type for the block writes to the flash of the
stm32. Depending on the family, the type has a different size. This
allows the removal of a number of ifdefs to track the differences
between families, simplifying the flashpage code
