Add USE_MODULE += "stdio_uart_onlcr" to enable it.
This is named after the "onlcr" stty flag, which does the same thing.
Co-authored-by: Marian Buschsieweke <marian.buschsieweke@ovgu.de>
Model the LoRaWAN integration to GNRC's netif command (ifconfig) as
submodule of it, namely `shell_cmd_gnrc_netif_lorawan`.
This should fix a regression introduced by
https://github.com/RIOT-OS/RIOT/pull/18355
When using podman instead of docker the registry is not set by default.
Docker has a builtin registry default "docker.io". Podman does not have a
default. By specifying the registry explicitly both tools can be used.
With RISC-V being a relatively young toolchain, a lot of inconsistencies
between different toolchains are to be found that differ in the target
triple and the flags supported. This build system performs run-time
tests to detect the toolchain and supported flags.
With `BUILD_IN_DOCKER=1` issues arise, as this checks are performed
outside of the docker container. However, the host may have no RISC-V
toolchain installed or a different toolchain, so there is little reason
in performing this detection then. Instead, a hard coded target triple
and supported flags are provided when using `BUILD_IN_DOCKER=1`.
If `AVRDUDE_PROGRAMMER` is already set to a programmer that is also
capable of debugging, we can assume that typically the user will want
to use the same hardware for debugging. Thus, let `AVR_DEBUGDEVICE`
default to the matching hardware.
`tiny_strerror()` is a drop-in replacement for `strerror()`, but
instead of a long help message it returns the much shorter macro name
matching the given number.
The (pseudo-)module `tiny_strerror_as_strerror` can be used to
replace all calls to `strerror()` with calls to `tiny_strerror()`.
Previously `shell_commands` was a "catch-all" module that included
shell commands for each and every used module that has a shell
companion. Instead, the new `shell_cmds` module is now used to provide
shell commands as individually selectable submodules, e.g.
`cmd_gnrc_icmpv6_echo` now provides the ICMPv6 echo command (a.k.a.
ping).
To still have a "catch all" module to pull in shell commands of modules
already used, `shell_cmds_default` was introduced. `shell_commands`
depends now on `shell_cmds_default` for backward compatibility, but
has been deprecated. New apps should use `shell_cmds_default`
instead.
For a handful of shell commands individual selection was already
possible. Those modules now depend on the corresponding `cmd_%` module
and they have been deprecated.
Add tracing support via GPIOs to trace the basic state of the Ethernet
peripheral. The following signals are provided:
- One GPIO pin is toggled on entry of the Ethernet ISR
- On TX start an GPIO is set, on TX completion it is cleared
- On RX complete an GPIO is set, once this is passed to the upper layer
the GPIO is cleared again
In order to reduce the overhead, GPIO LL is used. By default the
on-board LEDs are used as tracing GPIOs. This makes it easy to debug
when the state machine gets stuck without the need to attach a scope or
logic analyzer.
