In case a non-gpio EXTI (>= 16) is pending, the isr_exti() used to clear
the flag and try to call a callback, which was out-of-bouds, thus
generating a hard fault.
This fixes it by masking the pending_isr variables with 0xFFFF.
The ram size is exposed as macro value and available for use in code.
For the stm32 it has a value in kilobytes suffixed with 'k'. This is
less than optimal for usage in arithmetic. This commit modifies the
value to bytes so that it can be used in preprocessor magic
Add ENABLE_DEBUG_VERBOSE flag, so that the noise during debugging can be
reduced. This is super helpful when testing under load, as otherwise there is
just too much noise in the output.
An earlier version of periph_eth used to always pack the first chunk of the
outgoing frame to the first DMA descriptor by telling the DMA to jump back
to the first descriptor within the last descriptor. This worked fine unless
the frame was send in one chunk (as e.g. lwip does), which resulted due to a
hardware bug in a frame being send out twice. For that reason, the behavior was
changed to cycle throw the linked DMA descriptor list in round-robin fashion.
However, the error checking was not updated accordingly. Hence, the error
check might run over (parts of) unrelated frames and fail to detect errors
correctly.
This commit fixes the issue and also provides proper return codes for errors.
Additionally, an DMA reset is performed on detected errors during RX/TX. I'm
not sure if/when this is needed, as error conditions are neigh impossible to
produce. But better be safe than sorry.
This commits adds a common type for the block writes to the flash of the
stm32. Depending on the family, the type has a different size. This
allows the removal of a number of ifdefs to track the differences
between families, simplifying the flashpage code
Note that Kconfig.models was not generated with gen_kconfig.py tool
due to lack of ProductsList.xlsx file for STM32MP1 family.
Signed-off-by: Gilles DOFFE <gilles.doffe@savoirfairelinux.com>
