The module silabs_pic depends on the feature periph_i2c. However, the
dependency resolution just selected the module implementing that
feature which bypasses feature checks.
This fixes the following error:
$ BOARD=arduino-mega2560 make -C tests/pkg_arduino_sdi_12/
[...]
[...]/RIOT/build/pkg/arduino_sdi_12/src/SDI12_boards.cpp:35:16: error: ‘preSDI12_TCCR2B’ defined but not used [-Werror=unused-variable
35 | static uint8_t preSDI12_TCCR2B;
The esp8266 CPU has actually two hardware UART peripherals. UART0 is
used by the boot ROM for flashing and serial output during boot,
typically at a baudrate of 74880 bps until the bootloader or application
sets the more standard 115200 baudrate. This UART0 device has two
possible pins for TXD, GPIO1 and GPIO2, which are both set to TXD by the
boot ROM. esp8266 modules will typically have GPIO1 labeled as the TX
pin, but it is possible to use GPIO2 for that purpose even while
flashing the device with esptool.py.
The second device, UART1, also has two options for TXD, GPIO2 and GPIO7,
and only one option for RXD, GPIO8. However, GPIO7 and GPIO8 are used
by the flash internally so those options are not very useful unless
maybe while running from IRAM with the flash disabled, for example for
a debugger over UART1.
This patch allows boards to override UART{0,1}_{R,T}XD in their
periph_conf.h to configure the uart selection. Defining UART1_TX will
make the UART_DEV(1) device available.
Tested with:
```CFLAGS='-DUART1_TXD=GPIO2' make -C tests/periph_uart BOARD=esp8266-esp-12x flash term```
* Connected one USB-UART to the standard GPIO1 and GPIO3 for flashing
and console. After flashing we see the manual test output at 115200
bps
* Connected a second USB-UART with RX to GPIO2 running at 74880.
Then run on the first console:
```
> init 1 74880
> send 1 hello
```
The word "hello" appears on the second UART connection.
Note that GPIO2 is used during boot for UART0's TX until the application
or bootloader set it to a regular GPIO, so some boot ROM messages at
74880 bps are visible. After running `init 1 74880` it is set to UART1's
TX.
When flashing the ESP8266 with the flash tool it is possible to connect
RTS to the reset line and DTR to GPIO0 to automatically reboot the
device into flash mode and then reboot the device again into normal
mode.
pyterm leaves these two signals unset unless we specify a --set-rts=0 or
1, and the value of these lines would depend on the UART driver.
This patch explicitly sets RTS and DTR to 0 (high level) in the
Makefile.include config so `make term` releases the reset line,
otherwise the device may be left in reset mode after pyterm starts.
Add atxmega common board definitions. This works is a port from @josar
with few modifications.
Signed-off-by: Gerson Fernando Budke <nandojve@gmail.com>
Some mega boards enabling global irq at board_init. This moves that
responsability to cpu/avr8_common to create a common point to all
variants.
Signed-off-by: Gerson Fernando Budke <nandojve@gmail.com>
