.. | ||
contrib | ||
patches | ||
doc.txt | ||
Kconfig | ||
Makefile | ||
Makefile.dep | ||
Makefile.include | ||
Makefile.u8g2 | ||
Makefile.u8g2_csrc | ||
Makefile.u8g2_sdl | ||
Makefile.u8g2_utf8 | ||
README.md |
U8g2
Introduction
U8g2 is a monochrome graphics library for LCDs and OLEDs. It contains both drivers and high-level drawing routines.
The library is originally written for Arduino boards, but it runs just fine on other platforms, as long as the right drivers are available.
Usage
Just put USEPKG += u8g2
in your Makefile and #include "u8g2.h"
into your code. Refer to the U8g2 wiki for more information on the API.
RIOT-OS interface
This adds an interface for RIOT-OS.
The following two callbacks add support for the included drivers via I2C and SPI peripherals:
u8x8_byte_hw_spi_riotos
u8x8_byte_hw_i2c_riotos
For timing and GPIO related operations, the following callback is available.
u8x8_gpio_and_delay_riotos
These methods require a structure containing peripheral information (u8x8_riotos_t
), that is set using the u8g2_SetUserPtr
function. This structure contains the peripheral and pin mapping.
If the above interface is not sufficient, it is still possible to write a dedicated interface by (re-)implementing the methods above. Refer to the U8g2 wiki for more information.
Example
u8g2_t u8g2;
u8x8_riotos_t user_data =
{
.device_index = SPI_DEV(0),
.pin_cs = GPIO_PIN(PA, 0),
.pin_dc = GPIO_PIN(PA, 1),
.pin_reset = GPIO_PIN(PA, 2)
};
u8g2_SetUserPtr(&u8g2, &user_data);
u8g2_Setup_ssd1306_128x64_noname_1(&u8g2, U8G2_R0, u8x8_byte_riotos_hw_spi, u8x8_gpio_and_delay_riotos);
Virtual displays
For targets without an I2C or SPI, virtual displays are available. These displays are part of U8g2, but are not compiled by default.
- By adding
USEMODULE += u8g2_utf8
, a terminal display is used as virtual display, using UTF8 block characters that are printed to stdout. - By adding
USEMODULE += u8g2_sdl
, a SDL virtual display will be used. This is only available on native targets that have SDL installed. It usessdl2-config
to find the headers and libraries. Note that RIOT-OS builds 32-bit binaries and requires 32-bit SDL libraries.
Example
u8g2_t u8g2;
u8g2_SetupBuffer_Utf8(&u8g2, U8G2_R0);