set CHIPNAME STM32F103C8Tx

# Enable debug when in low power modes
set ENABLE_LOW_POWER 1

# Stop Watchdog counters when halt
set STOP_WATCHDOG 1

# STlink Debug clock frequency
set CLOCK_FREQ 4000

# Some revisions of the Bluepills use a CS32F103C8T6 rather than the STM32Fx
# MCU, which has a different CPUTAPID than the official STM32F103C8T6. As of
# 2020-04-09, no upstream support in OpenOCD has been merged. You can uncomment
# the following line as a workaround until your OpenOCD supports this option:
#set CPUTAPID 0x2ba01477

# Set the default reset option in cases where "SRST=none" is not used for make
if { ![info exists SRST_OPT] } {
   set SRST_OPT srst_only
}

# use hardware reset, connect under reset
# connect_assert_srst needed if low power mode application running (WFI...)
reset_config $SRST_OPT srst_nogate connect_assert_srst
set CONNECT_UNDER_RESET 1

source [find target/stm32f1x.cfg]

$_TARGETNAME configure -rtos auto