# Copyright (c) 2020 Freie Universitaet Berlin
#
# This file is subject to the terms and conditions of the GNU Lesser
# General Public License v2.1. See the file LICENSE in the top level
# directory for more details.
#
menuconfig KCONFIG_MODULE_AT86RF215
    bool "Configure AT86RF215 driver"
    depends on MODULE_AT86RF215
    help
        Configure the AT86RF215 driver using Kconfig.

if KCONFIG_MODULE_AT86RF215

config AT86RF215_USE_CLOCK_OUTPUT
    bool "Enable clock output"
    help
        Enable this to enable the clock output pin of the AT86RF215 chip.
        This way it can be used as a clock source in place of a separate crystal.
        You also have to enable this if you want to measure the clock frequency
        for trimming. After proper trim value is applied this may be disabled
        if not used otherwise.
        By Default it is turned off to save energy.

config AT86RF215_TRIM_VAL_EN
    bool "Enable crystal oscillator trimming"
    help
        Enable crystal oscillator trimming.

config AT86RF215_TRIM_VAL
    int "Trim value for the crystal oscillator"
    range 0 15
    default 0
    depends on AT86RF215_TRIM_VAL_EN
    help
        Each increment adds 300nF capacitance between the crystal oscillator pins
        TCXO and XTAL2.Tweak the value until the measured clock output matches
        26 MHz the best.
        For more information Refer Table 6-25 TRIM in Datasheet

endif # KCONFIG_MODULE_AT86RF215