/**
@defgroup    boards_nucleo-f303ze STM32 Nucleo-F303ZE
@ingroup     boards_common_nucleo144
@brief       Support for the STM32 Nucleo-F303ZE

## Overview

The Nucleo-F303 is a board from ST's Nucleo family supporting a ARM Cortex-M4
STM32F303RE
microcontroller with 64Kb of RAM and 512Kb of ROM.

## Hardware

![nucleo image](http://media.digikey.com/Photos/STMicro%20Photos/MFG_NUCLEO.jpg)
![nucleo-f303 pinout](https://raw.githubusercontent.com/wiki/RIOT-OS/RIOT/images/nucleo-f303_pinout.png)


### MCU
| MCU        | STM32F303RE           |
|:------------- |:--------------------- |
| Family | ARM Cortex-M4     |
| Vendor | ST Microelectronics   |
| RAM        | 64Kb                  |
| Flash      | 512Kb         |
| Frequency  | up to 72MHz) |
| FPU        | yes               |
| Timers | 14 (13x 16-bit, 1x 32-bit [TIM2]) |
| ADCs       | 4x 12-bit         |
| UARTs      | 5                 |
| SPIs       | 4                 |
| I2Cs       | 3                 |
| RTC        | 1                 |
| Vcc        | 2.0V - 3.6V           |
| Datasheet  | [Datasheet](http://www.st.com/st-web-ui/static/active/en/resource/technical/document/datasheet/DM00118585.pdf) |
| Reference Manual | [Reference Manual](http://www.st.com/web/en/resource/technical/document/reference_manual/DM00043574.pdf) |
| Programming Manual | [Programming Manual](http://www.st.com/web/en/resource/technical/document/programming_manual/DM00046982.pdf) |
| Board Manual   | [Board Manual](http://www.st.com/st-web-ui/static/active/en/resource/technical/document/user_manual/DM00105823.pdf)|



## Implementation Status
| Device | ID        | Supported | Comments  |
|:------------- |:------------- |:------------- |:------------- |
| MCU        | STM32F303RE   | partly    | Energy saving modes not fully utilized |
| Low-level driver | GPIO    | yes       | |
|        | PWM       | one PWM   | |
|        | UART      | three UART    | |
|        | I2C       | two I2C   | |
|        | SPI       | two SPI   | |
|        | USB       | no        | |
|        | Timer     | one 32 timer  | |


## Flashing the device
The ST Nucleo-F303RE board includes an on-board ST-LINK V2 programmer.
The easiest way to program the board is to use OpenOCD. Once you have
installed OpenOCD (look [here](https://github.com/RIOT-OS/RIOT/wiki/OpenOCD)
for installation instructions), you can flash the board simply by typing.

```
make flash
```
and debug via GDB by simply typing
```
make debug
```


## Supported Toolchains
For using the ST Nucleo-F303RE board we strongly recommend the usage of the
[GNU Tools for ARM Embedded Processors](https://launchpad.net/gcc-arm-embedded)
toolchain.
 */