/**
@defgroup    boards_nucleo-f072rb STM32 Nucleo-F072RB
@ingroup     boards_common_nucleo64
@brief       Support for the STM32 Nucleo-F072RB

## Overview

The Nucleo-F072 is a board from ST's Nucleo family supporting a ARM Cortex-M0
STM32F072RB microcontroller with 16Kb of SRAM and 128Kb of ROM Flash.

## Hardware

![Nucleo64 F072](http://www.open-electronics.org/wp-content/uploads/2015/08/Figura2-500x467.png)


### MCU
| MCU        | STM32F072RB           |
|:------------- |:--------------------- |
| Family | ARM Cortex-M0     |
| Vendor | ST Microelectronics   |
| RAM        | 16Kb |
| Flash      | 128Kb             |
| Frequency  | up to 48MHz) |
| FPU        | yes               |
| Timers | 12 (2x watchdog, 1 SysTick, 8x 16-bit, 1x 32-bit) |
| ADCs       | 1x 12-bit (up to 16 channels)         |
| UARTs      | 4                 |
| SPIs       | 2                 |
| I2Cs       | 2                 |
| RTC        | 1                 |
| Vcc        | 2.0V - 3.6V           |
| Datasheet  | [Datasheet](http://www.st.com/en/evaluation-tools/nucleo-f072rb.html) |
| Reference Manual | [Reference Manual](http://www.st.com/resource/en/datasheet/stm32f072rb.pdf) |
| Programming Manual | [Programming Manual](http://www.st.com/resource/en/reference_manual/dm00031936.pdf) |
| Board Manual   | [Board Manual](http://www.st.com/resource/en/user_manual/dm00105823.pdf)|


## Implementation Status

| Device | ID        | Supported | Comments  |
|:------------- |:------------- |:------------- |:------------- |
| MCU        | STM32F072RB   | partly    | Energy saving modes not fully utilized |
| Low-level driver | GPIO    | yes       | |
|        | PWM       | yes (4 pins available)    |  |
|        | UART      | 3 UARTs       | USART2 via STLink/USB or D0(RX)/D1(TX), USART1 on PA10(RX)/PA09(TX) and USART3 on PC11(RX)/PC10(TX) |
|        | PWM       | 7 pins        | |
|        | ADC       | 6 pins        | |
|        | I2C       | no        | |
|        | SPI       | yes (SPI1)        | |
|        | USB       | no        | |
|        | Timer     | 1 32 bit timers (TIM1)        | |


## Flashing the device
The ST Nucleo-F072 board includes an on-board ST-LINK V2 programmer. The
easiest way to program the board is to use OpenOCD. Once you have installed
OpenOCD (look [here](https://github.com/RIOT-OS/RIOT/wiki/OpenOCD) for
installation instructions), you can flash the board simply by typing

```
make BOARD=nucleo-f072 flash
```
and debug via GDB by simply typing
```
make BOARD=nucleo-f072 debug
```


## Supported Toolchains
For using the ST Nucleo-F072 board we strongly recommend the usage of the
[GNU Tools for ARM Embedded Processors](https://launchpad.net/gcc-arm-embedded)
toolchain.
 */