/**
@defgroup    boards_nucleo-l152re STM32 Nucleo-L152RE
@ingroup     boards_common_nucleo64
@brief       Support for the STM32 Nucleo-L152RE

## Hardware

![Nucleo64 L152RE](http://www.open-electronics.org/wp-content/uploads/2015/08/Figura2-500x467.png)


### MCU
| MCU        | STM32L152RE       |
|:---------- |:----------------- |
| Family     | ARM Cortex-M3     |
| Vendor     | ST Microelectronics |
| RAM        | 80Kb              |
| Flash      | 512Kb             |
| EEPROM     | 16KB              |
| Frequency  | up to 32MHz       |
| FPU        | no                |
| Timers     | 12 (8x 16-bit, 1x 32-bit [TIM5], 1x Systick, 2x watchdog) |
| ADCs       | 1x 12-bit (21 channels) |
| UARTs      | 5                 |
| SPIs       | 3-8 (UARTs can be configured as SPIs) |
| I2Cs       | 2                 |
| Vcc        | 1.65V - 3.6V      |
| Datasheet  | [Datasheet](https://www.st.com/resource/en/datasheet/stm32l152re.pdf) |
| Reference Manual | [Reference Manual](http://www.st.com/resource/en/reference_manual/cd00240193.pdf) |
| Programming Manual | [Programming Manual](http://www.st.com/web/en/resource/technical/document/programming_manual/CD00228163.pdf) |
| Board Manual | [Board Manual](http://www.st.com/st-web-ui/static/active/en/resource/technical/document/user_manual/DM00105823.pdf) |

### User Interface

2 Buttons:

| NAME   | USER      | RESET |
|:------ |:--------- |:----- |
| Pin    | PC13 (IN) | NRST  |

1 LED:

| NAME   | LD2   |
| -----  | ----- |
| Color  | green |
| Pin    | PA5   |


## Supported Toolchains

For using the Nucleo-L152RE board we strongly recommend the usage of the [GNU
Tools for ARM Embedded Processors](https://launchpad.net/gcc-arm-embedded)
toolchain.

### OpenOCD

Please use an OpenOCD version checked out after Jan. 26th 2015. Building
instructions can be found [here](https://github.com/RIOT-OS/RIOT/wiki/OpenOCD).

## Using UART

Using the UART isn't too stable right now. For some using the USB interface
just works, others have to connect the USB interface to a active USB hub and
others again can only transmit over the USB interface and receive using an
external UART adapter.

#### Connecting an external UART adapter

1. connect your usb tty to the st-link header as marked
![st-link-header](https://cloud.githubusercontent.com/assets/56618/5190200/f36aafe0-74e3-11e4-96bd-f755dd2a8b01.png)
2. done
 */