Replace direct accesses to sched_active_thread and sched_active_pid with
the helper functions thread_getpid() and thread_get_active(). This serves
two purposes:
1. It makes accidental writes to those variable from outside core less likely.
2. Casting off the volatile qualifier is now well contained to those two
functions
These functions are independent from GNRC and can be used by stack-agnistoc
code.
Avoid pulling in a GNRC dependency by moving those two helper functions to
`netif`.
The old function names are kept as `static inline` wrapper functions to avoid
breaking API users.
The 6Lo network interfaces can only support a max_frag_size of
SIXLOWPAN_FRAG_MAX_LEN (2047 bytes) as the length field is only 11-bits.
This limits the max_frag_size in the case that the L2-PDU is higher than
that.
Signed-off-by: Jean Pierre Dudey <jeandudey@hotmail.com>
802.15.4g devices have a 2047 byte PDU.
So the assertion `netif->ipv6.mtu == IPV6_MIN_MTU` is too strict here.
This is only enforced on init, so changing the modulation at run-time
did not catch this bug.
To test, use e.g. `at86rf215` with
CFLAGS += -DAT86RF215_DEFAULT_PHY_MODE=IEEE802154_PHY_MR_OQPSK
fixes#14164
Add a message bus where threads can listen for nib events.
Currently only the GNRC_IPV6_NIB_EVENT_ADDR_VALID event is
implemented which informs subscribers that an address got
valid.
Enabled by the gnrc_netif_events pseudo module. Using an internal event
loop within the gnrc_netif thread eliminates the risk of lost interrupts
and lets ISR events always be handled before any send/receive requests
from other threads are processed.
The events in the event loop is also a potential hook for MAC layers and
other link layer modules which may need to inject and process events
before any external IPC messages are handled.
Co-Authored-By: Koen Zandberg <koen@bergzand.net>
This is the radio found in NXP Kinetis KW41Z, KW21Z. Only 802.15.4 mode
is implemented (KW41Z also supports BLE on the same transceiver).
The driver uses vendor supplied initialization code for the low level
XCVR hardware, these files were imported from KSDK 2.2.0 (framework_5.3.5)
This adds a driver for the SPI based AT86RF215 transceiver.
The chip supports the IEEE Std 802.15.4-2015 and IEEE Std 802.15.4g-2012 standard.
This driver supports two versions of the chip:
- AT86RF215: dual sub-GHz & 2.4 GHz radio & baseband
- AT86RF215M: sub-GHz radio & baseband only
Both radios support the following PHY modes:
- MR-FSK
- MR-OFDM
- MR-O-QPKS
- O-QPSK (legacy)
The driver currently only implements support for legacy O-QPSK.
To use both interfaces, add
GNRC_NETIF_NUMOF := 2
to your Makefile.
The transceiver is able to send frames of up to 2047 bytes according to
IEEE 802.15.4g-2012 when operating in non-legacy mode.
Known issues:
- [ ] dBm setting values are bogus
- [ ] Channel spacing for sub-GHz MR-O-QPSK might be wrong
- [ ] TX/RX stress test will lock up the driver on openmote-b
