Lists state, link type, v4/v6 addresses.
Currently read-only.
Using lwIP debug system to print addresses, to limit dependencies
and work with dual stack setup. Most other code seems to only
allow either v4 or v6 networking. For that to compile I
had to change the `SZT_F` format string due to this error:
```
error: format '%lu' expects argument of type 'long unsigned int',
but argument 2 has type 'size_t {aka unsigned int}'
```
Switching to the lwIP default format string here.
Outputs the following on my ESP32 board with Ethernet,
when both v4 and v6 are enabled in examples/paho-mqtt:
```
> ifconfig
Iface ET0 HWaddr: 24:0a:c4:e6:0e:9f Link: up State: up
Link type: wired
inet addr: 10.4.4.81 mask: 255.255.254.0 gw: 10.4.4.1
inet6 addr: fe80:0:0:0:260a:c4ff:fee6:e9f scope: link
inet6 addr: 2001:db8:1000:0:260a:c4ff:fee6:e9f scope: global
Iface ET1 HWaddr: 24:0a:c4:e6:0e:9c Link: up State: up
Link type: wireless
inet addr: 10.4.4.82 mask: 255.255.254.0 gw: 10.4.4.1
inet6 addr: fe80:0:0:0:260a:c4ff:fee6:e9c scope: link
inet6 addr: 2001:db8:1000:0:260a:c4ff:fee6:e9c scope: global
>
```
Previously a value of 0 was used for the RSSI to signal that this value is not
present in `gnrc_netif_hdr_t`. However, an RSSI of 0 dBm is legal and even very
plausible data.
This commit defines `GNRC_NETIF_HDR_NO_RSSI` as `INT16_MIN`, which is below the
noise floor in the vacuum of outer space and hence impossible to receive.
For consistency, also GNRC_NETIF_HDR_NO_LQI is defined.
Replace direct accesses to sched_active_thread and sched_active_pid with
the helper functions thread_getpid() and thread_get_active(). This serves
two purposes:
1. It makes accidental writes to those variable from outside core less likely.
2. Casting off the volatile qualifier is now well contained to those two
functions
In most places, picolibc and newlib are the same, so use
the existing newlib code when compiling with picolibc.
Signed-off-by: Keith Packard <keithp@keithp.com>
Originally, the options and flags in the `netif` shell output were
separated by two spaces. For later added flags this is not the case,
making the parsing of those flags and options hard to impossible.
This change adds those missing spaces + comments so it might not happen
again in the future.
