cpu/$(CPU)/Makefile.features and cpu/$(CPU)/Makefile.dep are
automatically included
Part of moving CPU/CPU_MODEL definition to Makefile.features to have it
available before Makefile.include.
MSPDEBUGFLAGS is evaluated only in the same file.
Its value does not need to be exported.
This will also prevent evaluating 'PORT' for MSPDEBUGFLAGS when not needed.
DEBUGGER/DEBUGGER_FLAGS/DEBUGSERVER/DEBUGSERVER_FLAGS are evaluated by the
main Makefile.include or by file included by it.
Their value does not need to be exported.
Testing
-------
`git diff --word-diff` only reports `export` being removed.
`git show --stat` reports `55 insertions(+), 55 deletions(-)`
Which is the same amount as lines that where matching
`export[[:blank::]]\+VARIABLE`.
FLASHER and FFLAGS are evaluated by the main Makefile.include or by file
included by it. Their value does not need to be exported.
This will also prevent evaluating 'PORT' for FFLAGS when not needed.
Testing
-------
`git diff --word-diff` only reports `export` being removed.
`git show --stat` reports `84 insertions(+), 84 deletions(-)`
Which is the same amount as lines that where matching
`export[[:blank::]]\+VARIABLE`.
- Use RIOT's GPIO interface to access the sensor to increase portability
- Changed API to allow more than one sensor per board
- Added `sht1x_params.h` that specifies how the sensors is connected - each
board can overwrite default settings by #defining SHT1X_PARAM_CLK and
SHT1X_PARAM_DATA
- Changed arithmetic to use integer calculations only instead of floating point
arithmetic
- Added support for checking the CRC sum
- Allow optional skipping of the CRC check to speed up measuring
- Added support for advanced features like reducing the resolution and skipping
calibration to speed up measuring
- Allow specifying the supply voltage of sensor which heavily influences the
temperature result (and use that information to calculate the correct
temperature)
- Reset sensor on initialization to bring it in a well known state
- Support for the obscure heater feature. (Can be useful to check the
temperature sensor?)
- Updated old SHT11 shell commands to the new driver interface, thus allowing
more than one SHT10/11/15 sensor to be used
- Added new shell command to allow full configuration of all attached SHT1x
sensors
- Removed old command for setting the SHT11 temperature offset, as this feature
is implemented in the new configuration command
