The 'msba2' common files have accumulated many empty files are files that
do nothing.
This makes reasoning about the boards needlessly difficult.
Trim down on `common/msba2/` so that it now only contains the setup for the
UART/bootloader based flashing.
This should eventuelly be moved to `makefiles/tools/`
- Moved compiler & linker flags from boards/common/msba2 to cpu/arm7_common
- Moved dependency to newlib nano to cpu/arm7_common
- Moved config to link in cpu/startup.o to cpu/arm7_common
The boards are using `pyterm` specific options that do not work on any
other `RIOT_TERMINAL`. It is a shame this is required but at least do
not pass arbitrary arguments to the other RIOT_TERMINAL.
So use the new PYTERMFLAGS for this.
cpu/$(CPU)/Makefile.features and cpu/$(CPU)/Makefile.dep are
automatically included
Part of moving CPU/CPU_MODEL definition to Makefile.features to have it
available before Makefile.include.
Add a rule to build `lpc2k_pgm` when flashing.
It is only compiled if it is using the one in `tools`.
If overwritten to `lpc2k_pgm` if it should be taken from the path,
it is not compiled.
The compilation is still done in `boards/common/msba2/tools` as it was
the case before and this commit does not address this.
Boards should not set PORT and should not have code conditional on
PORT as that causes PORT to be evaluated and the build to fail even
if this varible is not needed.
Exporting has the same effect.
This fixes the MSBA2 board by declaring PORT_LINUX and PORT_DARWIN
instead.
- Use RIOT's GPIO interface to access the sensor to increase portability
- Changed API to allow more than one sensor per board
- Added `sht1x_params.h` that specifies how the sensors is connected - each
board can overwrite default settings by #defining SHT1X_PARAM_CLK and
SHT1X_PARAM_DATA
- Changed arithmetic to use integer calculations only instead of floating point
arithmetic
- Added support for checking the CRC sum
- Allow optional skipping of the CRC check to speed up measuring
- Added support for advanced features like reducing the resolution and skipping
calibration to speed up measuring
- Allow specifying the supply voltage of sensor which heavily influences the
temperature result (and use that information to calculate the correct
temperature)
- Reset sensor on initialization to bring it in a well known state
- Support for the obscure heater feature. (Can be useful to check the
temperature sensor?)
- Updated old SHT11 shell commands to the new driver interface, thus allowing
more than one SHT10/11/15 sensor to be used
- Added new shell command to allow full configuration of all attached SHT1x
sensors
- Removed old command for setting the SHT11 temperature offset, as this feature
is implemented in the new configuration command
