This implements `pm_set_lowest()` for the MSP430. Unlike most other
platforms, it intentionally does not use pm_layered. It is pretty
similar to `pm_layered` in that is does use reference counters, but it
uses them for two independent clock sources.
The main difference is that the low frequency clock domain can be
disabled even when the high frequency clock is still active. With the
layers, disabling layer n-1 while layer n is still blocked would not
work.
- Move common code for USART (shared SPI / UART peripheral) to its
own file and allow sharing the USART peripheral to provide both
UART and SPI in round-robin fashion.
- Configure both UART and SPI bus via a `struct` in the board's
`periph_conf.h`
- this allows allocating the two UARTs as needed by the use case
- since both USARTs signals have a fixed connection to a single
GPIO, most configuration is moved to the CPU
- the board now only needs to decide which bus is provided by
which USART
Note: Sharing an USART used as UART requires cooperation from the app:
- If the UART is used in TX-only mode (no RX callback), the driver
will release the USART while not sending
- If the UART is used to also receive, the application needs to power
the UART down while not expecting something to send. An
`spi_acquire()` will be blocked while the UART is powered up.
