setting NETOPT_ENCRYPTION_KEY in device driver was redundant
because it is also done in the ieee802154 netdev driver
and the key is transfered to the hardware in the ieee802154
security implementation
The assert is reversed. It must check if the config value does not
exceed the maximum address length, not the other way round.
previously this would lead to a crash when setting a short address:
2020-08-23 13:59:56,080 # ifconfig 7 set addr_short 2
2020-08-23 13:59:56,081 # 0xdcad
2020-08-23 13:59:56,083 # *** RIOT kernel panic:
2020-08-23 13:59:56,085 # FAILED ASSERTION.
With this it works as expected
2020-08-23 14:05:07,988 # ifconfig 7 set addr_short 2
2020-08-23 14:05:07,992 # success: set (short) address on interface 7 to 2
AT86RF2xx supports high data rates in O-QPSK mode.
This is a proprietary feature, so data rates > 0 are only supported by
other AT86RF2xx devices.
high_rate 0: 250 kbit/s (IEEE mode)
high_rate 1: 500 kbit/s
high_rate 2: 1000 kbit/s (compatible with at86rf215)
high_rate 3: 2000 kbit/s
The at86rf2xx radio handled a transfer complete condition with the radio
in the BUSY_TX_ARET state as a finished transmission. This condition and
state also occurs when a reception occurs just before switching to
transmitting. This would cause a condition where first a TX_COMPLETE was
signalled and second a RX_COMPLETE was signalled. The network stack
would then read the transmitted frame as a received frame.
The patch fixes the errornous RX callback by only submitting the
TX_COMPLETE condition when there are at least 2 frames pending
(at86rf2xx::pending_tx).
The ATmega128RFA1 and ATmega256RFR2 contain a version of this IP
on the MCU.
The radio core behaves mostly like a at86rf231, but all registers
are mapped to memory and radio states can directly generate interrupts
on the CPU.
The ATmega256RFR2 adds support for automatic retransmissions.
This has not been implemented yet.
Co-authored-by: Josua Arndt <jarndt@ias.rwth-aachen.de>
This PR sets the tranceiver in PLL_ON state to avoid corruption of the
data in the frame buffer and sets it back to the last state which the
transceiver had before changing into transmit mode after the data is
read out. This is done to avoid data corruption when `_recv(...)` is
called to retrieve the buffer size and frame buffer protection is released.
AT86RF231 MAN. p.89 8.3.2 Reading RSSI
AT86RF232 MAN. p.88 8.3.2 Reading RSSI
AT86RF233 MAN. p.99 8.4.2 Reading RSSI
"It is not recommended reading the RSSI value when using the Extended Operating Modes, use ED instead"
The flags from the ieee802154 struct are only used in the radio code.
there is no advantage of having them in the netdev_ieee802154_t struct
if the flags are defined differently per radio driver.
