Add ATmega328P Xplained Mini board. The board is an official
development kit from MCHP based on the Arduino UNO, reduced
hardware, with a xplainedmini debugger and CDC ACM serial
converter.
Signed-off-by: Gerson Fernando Budke <nandojve@gmail.com>
Add atxmega-a1u-xpro board to BOARD_INSUFFICIENT_MEMORY list to
exclude examples since board don't have enough data memory.
Signed-off-by: Gerson Fernando Budke <nandojve@gmail.com>
If `native` is compiled with `USEMODULE=socket_zep` and networking,
don't also include `netdev_tap` automatically.
This mirrors the behavior on nrf52 and esp* where the default netdev
can be 'overwritten' by another option.
stm32mp157c-dk2 has not enough memory to build this apps.
However as the stm32mp157xx cpu line has no flash, a part of RAM
is considered as ROM. Thus ROM size could be extend to suit this
apps needs.
Signed-off-by: Gilles DOFFE <gilles.doffe@savoirfairelinux.com>
This changes the prefixes of the symbols generated from USEMODULE and
USEPKG variables. The changes are as follow:
KCONFIG_MODULE_ => KCONFIG_USEMODULE_
KCONFIG_PKG_ => KCONFIG_USEPKG_
MODULE_ => USEMODULE_
PKG_ => USEPKG_
The other applications using `sock_dns` do it too
(`tests/gnrc_sock_dns` and `tests/gnrc_ipv6_nib_dns`) and besides it
doesn't make much sense to include RDNSS option support
(aka `gnrc_ipv6_nib_dns`) just because someone uses the DNS client
(aka `sock_dns`). This dependency will be removed in a later commit.
Optionally executes pyterm from CDC-ECM start_network.sh
The shell script exits and cleans up instantly unless there is a
blocking program running at the end. Users can supply a serial port to
display in pyterm, or alternatively just wait if it is a "headless"
deployment.
Native supports multiple ZEP devices, so add a config option for it to
gnrc_border_router.
This allows for easier testing of border routers with multiple interfaces.
This adds an example configuration to use the gnrc_border_router to route
between a regular WiFi network and an esp_now network.
All you need is an esp based board (esp8266, esp32).
Configure the access data for your WiFi network in `Makefile.esp.conf`,
then run
make BOARD=esp32-wroom-32 USE_ETHOS=0 USE_ESP=1 flash term
to turn a e.g. `esp32-wroom-32` into a boarder router.
You can use other esp based boards as nodes in the network by flashing
e.g. the `gnrc_networking` example.
Be sure to add `CFLAGS += -DGNRC_IPV6_NIB_CONF_SLAAC=1` as otherwise
your esp_now node will not receive a link-local IP address.
Previous value was 20 K, now it's 80 K. The older family of these MCUs
(cc13x0, cc26x0) had that size, currently for cc13x2 and cc26x2 it's
80 K.
Signed-off-by: Jean Pierre Dudey <jeandudey@hotmail.com>
