RIOT/boards/esp32-ethernet-kit-v1_0/Makefile.dep

include $(RIOTBOARD)/common/esp32/Makefile.dep

# enables esp_eth as default network device
ifneq (,$(filter netdev_default,$(USEMODULE)))
  USEMODULE += esp_eth
endif

# saul_gpio does conflict eth, as the only SAUL enabled GPIO is the boot button.
# But that GPIO doubles as phy clock input.
ifneq (,$(filter esp_eth,$(USEMODULE)))
  DISABLE_MODULE += saul_gpio
endif

ifneq (,$(filter saul_default,$(USEMODULE)))
  DEFAULT_MODULE += saul_gpio
endif
boards/esp32: add ESP32-Ethernet-Kit board Mostly copied from esp32-wroom-kit and Ethernet part from esp32-olimex-evb. Ethernet and serial port has been tested (on v1.2 board). 2020-07-10 13:53:46 +02:00			`include $(RIOTBOARD)/common/esp32/Makefile.dep`

			`# enables esp_eth as default network device`
			`ifneq (,$(filter netdev_default,$(USEMODULE)))`
			`USEMODULE += esp_eth`
			`endif`
boards/esp32*: move saul_gpio dep to board level The ESP32 Ethernet Kit has only a single GPIO pin exposed to SAUL via `saul_gpio`, but that GPIO doubles as PHY clock input when `esp32_eth` is used. Hence, the `saul_gpio` dep should be optional and only kick in when `esp32_eth` is not used. 2024-05-22 13:38:33 +02:00
			`# saul_gpio does conflict eth, as the only SAUL enabled GPIO is the boot button.`
			`# But that GPIO doubles as phy clock input.`
			`ifneq (,$(filter esp_eth,$(USEMODULE)))`
			`DISABLE_MODULE += saul_gpio`
			`endif`

			`ifneq (,$(filter saul_default,$(USEMODULE)))`
			`DEFAULT_MODULE += saul_gpio`
			`endif`