RIOT/boards/msb-430h/Makefile.dep

ifneq (,$(filter saul_default,$(USEMODULE)))
  USEMODULE += sht11
endif

USEMODULE += boards_common_msb-430
drivers/sht1x: Major refactoring - Use RIOT's GPIO interface to access the sensor to increase portability - Changed API to allow more than one sensor per board - Added `sht1x_params.h` that specifies how the sensors is connected - each board can overwrite default settings by #defining SHT1X_PARAM_CLK and SHT1X_PARAM_DATA - Changed arithmetic to use integer calculations only instead of floating point arithmetic - Added support for checking the CRC sum - Allow optional skipping of the CRC check to speed up measuring - Added support for advanced features like reducing the resolution and skipping calibration to speed up measuring - Allow specifying the supply voltage of sensor which heavily influences the temperature result (and use that information to calculate the correct temperature) - Reset sensor on initialization to bring it in a well known state - Support for the obscure heater feature. (Can be useful to check the temperature sensor?) - Updated old SHT11 shell commands to the new driver interface, thus allowing more than one SHT10/11/15 sensor to be used - Added new shell command to allow full configuration of all attached SHT1x sensors - Removed old command for setting the SHT11 temperature offset, as this feature is implemented in the new configuration command 2018-06-13 09:17:29 +02:00			`ifneq (,$(filter saul_default,$(USEMODULE)))`
			`USEMODULE += sht11`
			`endif`
boards: move some USEMODULE to Makefile.dep 2020-02-04 22:28:59 +01:00
			`USEMODULE += boards_common_msb-430`